Next stage of the tower/shack project will be worked on Saturday. I’ve already fitted the plywood floor but could really do with some help fitting the ply sheets for the walls and roof. I need to cut these using my table saw, but they are just a bit on the big side to handle carefully/accurately on my own.
OK, appreciate it was a bit short notice. I re-primed the house fascia boards instead but have taken out all the lengths of plywood and pencilled on all parts that require sawing. I did drag the table saw out but the wood sheets are just too long for one person to cut them safely and accurately. Is anyone available for about 1/2hr some night this week to do this?
OK Guys, Will try and spend a day cutting and fitting the panels when I get back from IOTA. In the meantime, the floor has been fitted and is covered with a tarpaulin, although weve not had rain here for about a fortnight and it’s not forecast to rain for a week atm.
If it gets any wider you might be able to ask them on FM.
I’m in Glenrothes, but not me. I’ve not done ft8 or any digital modes on 2m. I’ve done 6m, but not higher. MM7MTB
Certainly south of Fife but no ft8 here
In Midlothian; but not been on air today. MM0LBF
Not just me then - yes saw the same thing here (Pathhead) - tried pre amp off, att on, swung beam to get weaker signal - no difference no decode. Did hear a 'thump' about 2 sec before - it caused the harmonics and them distorted and wide audio. Could not take a guess at who it was - not seen anyone with that signal strength recently.